I’m currently looking into installing the solenoid and driver in my standard (not compact) F77 but am uncertain about the installation location for the solenoid and in particular the driver. The solenoid installation video https://www.youtube.com/watch?v=Z0QNCkGcwhA mentions that the driver can be “placed in the empty space between the solenoid and the controller” but doesn’t show a recommended location or if it should be screwed/mounted to the case (I just want to avoid a short circuit as the case is made of metal.) Is there a zoomed-out photo of the entire keyboard showing the locations of where both the solenoid and its driver are installed? Also do the mounting holes need to be drilled/added for both of them or is it intended for the existing drainage holes to be used for that purpose on the bottom part of the case? Any clarification that can be provided will be greatly appreciated 🙂
Thanks for the fast response 🙂 Just to clarify, when you mention “taping the bottom solenoid driver through hole points”, do you mean taping/securing the underneath of the driver to the bottom part of the case via a loop/ring of electrical tape with the adhesive on the outside (essentially a makeshift double-sided tape)? If so, how to the hole points factor into it?